![]() In the “Restore from file” section, select “Browse” and search for the “BCPKG2-1-Normal-Main.bin” file inside of the NX-X.X.X folder generated earlier with ChoiDujour. Clear them and press “Test” if they are not. Make sure both BIS key text boxes are BLANK. Make sure you see a list of partitions as shown below Close HacDiskMount and hold the power button on your Switch to shut down. If you do not see this device with the exact name, STOP! You cannot continue. Right click HacDiskMount.exe and choose “Run as Administrator”Ĭhoose File > Open Physical Drive from the menu barĬhoose Linux UMS disk 0 (29.121GiB). Locate HacDiskMount which you extracted earlier You cannot continue until you see this device. If you still cannot see “LINUX UMS DISK 0” under “Disk Drives”, STOP! Press and hold the power button to shutdown the Switch and try steps 5.3-5.5 again. Right click and choose uninstall.Īfter doing the above, choose “Scan for hardware changes” in the Device Manager toolbar If you cannot see this, look through Device Manager for any devices with a yellow warning icon. If you see “USB Download Gadget”, right click the entry and choose Uninstall. Because of this, AutoRCM is required to boot your Switch until you upgrade again.ĪutoRCM can always be disabled Hekate > Tools > AutoRCM If you are downgrading, your fuse count will be incorrect for that firmware version. ![]() You will not be able to boot your Switch at all without a payload sender. You will never accidentally boot stock firmware, meaning you can avoid having telemetry data accidentally sent to Nintendo. The Switch will not burn any fuses, meaning you can downgrade your Switch to a lower firmware version in the future should the need arise. You will be able to bypass the normally required fuse count, allowing you to launch any firmware version of your choosing. This might sound scary but is not actually dangerous, and can be undone at any time. Essentially, you are purposefully bricking your Switch in a controlled matter that forces it to launch into recovery. AutoRCM is a software method of forcing your Switch to go into RCM on every launch, without the need of a jig or hardmod.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |